Problem
Possible solution
Too much foam in the
drum during the wash‐
ing cycle.
• Reduce the quantity of detergent.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
• Make sure that the flap is in the correct position.
• Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
14. TECHNICAL DATA
Dimension
Width/ Height/ Depth/
Total depth
400 mm/ 890 mm/ 600 mm/ 600
mm
Electrical connection
Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Level of protection against ingress of solid parti‐
cles and moisture ensured by the protective cov‐
er, except where the low voltage equipment has
no protection against moisture
IPX4
Water supply pressure Minimum
Maximum
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Water supply 1)
Cold water
Maximum Load
Cotton
7 kg
Energy Efficiency Class
A+++
Spin Speed
Maximum spin speed
1251 rpm
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
ENGLISH
31
