Electrolux EW6F428W, Руководство пользователя

Страница: 30 / 40

WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
14. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
14.1 Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists,
contact the Authorised Service Centre.
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
alarm code and the Start/Pause
button may flash continuously:
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it
off and switch on again. The programme was not finished properly or the appliance
stopped too early. If the alarm code appears again, contact the Authorised Service
Centre.
• - The appliance does not fill with water properly. After the proper check, start
the appliance again by pressing Start/Pause button the appliance tries to
resume the cycle . If the error persists the alarm code will appear again.
• - The appliance does not drain the water.
• - The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum
and/or hold the door shut while touching the Start/Pause
button
until the indicator stops flashing (see the picture below).
www.electrolux.com 30