Electrolux ESF65052, Руководство пользователя

Страница: 17 / 20

water fill, the drain hose and the power sup-
ply cable pass through.
Make sure that there are no kinks in the water
hoses and that the water hoses are not
squashed.
Adjusting the height of the appliance
Do these steps to adjust the height of the
appliance:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot. Turn the screw in the
middle of the front kick plate to the left or
to the right.
Make sure that the appliance is level to
close and seal the door correctly. If the
level of the appliance is correct, the door
does not catch on the sides of the cab-
inet. If the door does not close correctly,
loosen or tighten the adjustable feet until
the appliance is level.
Adjusting the height of the plinth
If there is a space at the bottom of the ma-
chine, you can lower the plinth to cover it.
Adhesive steam protection foil
Fit the steam protection on the front part of
the worktop along the entire width.
600 mm
Fixing to the adjacent units
Warning! Use the supplied brackets to
attach the appliance under the worktop
or to the adjacent units, to prevent injury
or damage.
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
2. Use the supplied screws to secure the
appliance in position (upwards or side-
ways). Make sure the screws are tight-
ened.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4”.
electrolux 17