Electrolux EN3855MFX, Руководство пользователя

Страница: 10 / 16

Problem Possible cause Solution
Food products placed in
the appliance were too
warm.
Allow food products to cool
to room temperature before
storing.
The FastFreeze function
is switched on.
Refer to "FastFreeze func‐
tion".
The compressor does not
start immediately after
pressing the FastFreeze
or after changing the tem‐
perature.
This is normal, no error
has occurred.
The compressor starts after
some time.
Water flows inside the re‐
frigerator.
The water outlet is clog‐
ged.
Clean the water outlet.
Food products prevent
water from flowing into
the water collector.
Make sure that food prod‐
ucts do not touch the rear
plate.
Water flows on the floor. The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The FastFreeze or Shop‐
pingMode function is
switched on.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem‐
perature. Refer to "Fast‐
Freeze or ShoppingMode
function".
The temperature in the
appliance is too low/too
high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The food products tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
Many food products were
stored at the same time.
Store less food products at
the same time.
The FastFreeze function
is switched on.
Refer to "FastFreeze func‐
tion".
Side panels of the appli‐
ance are warm.
This is a normal state
caused by operation of
the heat exchanger.
Make sure that there is at
least 30 mm of space be‐
tween each side of the appli‐
ance and the surrounding
furniture when the ambient
temperature exceeds 38°C.
www.electrolux.com 10