Grease Collector
Periodically empty the grease cup and clean with dishwashing detergent and
hot water solution.
Cleaning the burner assembly (Make sure the grill is cool)
1. Turn gas off at the control knobs and propane tank.
2. Remove cooking grates and heat shield.
3. Remove grease collector.
4. Remove burner by unscrewing nut from beneath burner "foot" using a
screwdriver and pliers.
5. Lift burner up and away from gas valve orifice.
6. Clean inlet (venturi) of burner with small bottle brush or compressed air.
7. Remove all food residue and dirt on outside of burner surface.
8. Clean any clogged ports with a stiff wire (such as an opened paper clip).
9. Inspect burner for any damage (cracks or holes). If damage is found, replace
with new burner. Reinstall burner; check to ensure that gas valve orifices are
correctly positioned inside burner inlet (venturi).
Overlap 3/4” between venturi tube and
nozzle when assembled.
Keep the center line of venturi tube
and nozzle on one line.
If the instructions above are not followed, an explosion may result, possibly
causing serious bodily injury or death.
Troubleshooting
60
electrolux
59 electrolux
care and cleaning
Troubleshooting
Please refer to the following Troubleshooting Guide if you have any problems
lighting or operating your grill. Many solutions given here can make your grilling
experience safer and more enjoyable.
Problem
Possible Solutions
Low heat, LP gas
Low heat, natural gas
Low heat generated with
Knob in “HI” position
The propane regulator assembly incorporates an excess
flow device designed to supply the grill with sufficient gas
flow under normal conditions, yet control excess gas flow.
Rapid changes in pressure can trigger the excess flow
device, providing a low flame and low temperature.If the
tank valve is turned open to allow gas flow while a burner
valve is open, the surge of pressure will cause the device
to activate. The device will remain closed until the pressure
is equalized. This should occur within 5 seconds.
To ensure this does not cause difficulty in lighting the grill,
follow these instructions:
1. Make sure all burner valves are “OFF”.
2. Open the tank valve and wait 5 seconds.
3. Light the burner one at a time following the lighting
instructions listed on the control box and Page 22.
Gas pressure is affected by gas line and length of gas line
from house gas line. Follow the recommendations in the
chart below.
1.Make certain the problem is isolated to only one burner.
If it appears so, clean the orifice and burner, clearing
ports of any obstruction.
2.Check for a bent or kinked fuel hose.
3.Make sure the air shutter is properly adjusted.
4.Check for proper gas supply and pressure.
5.Pre-heat the grill for a full 15 minutes.
6.If using LP gas, check for an empty tank.
From House to Grill
Distance
Up to 25 foot
26-50 foot
51-100 foot
1/3 inch of run 1/2 inch
Tubing Size
1/2 inch diameter
2/3 inch of run 3/4 inch
3/8 inch diameter
E
N
G
E
N
G
