Electrolux EKG913B3OX, Руководство пользователя

Страница: 10 / 32

4.1 Initial Cleaning
Remove all accessories from the
appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance and the accessories
before first use.
Put the accessories back to their initial
position.
4.2 Preheating
Preheat the empty appliance to burn off
the remaining grease.
1. Set the maximum temperature.
2. Let the appliance operate for
approximately 1 hour.
WARNING!
Accessories can become
hotter than usual.
The appliance can emit an odour and
smoke. This is normal. Make sure that
the airflow is sufficient.
Let the oven cool down. Dampen a soft
cloth with warm water and a little mild
washing-up liquid and use this to clean
the oven cavity.
5. HOB - DAILY USE
WARNING!
Refer to Safety chapters.
5.1 Ignition of the hob burner
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you
use open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
The spark generator can
start automatically when you
switch on the mains, after
installation or a power cut. It
is normal.
In the absence of electricity
you can ignite the burner
manually.
Ignition of a hob burner with the
thermocouple
• For manual ignition put the flame near
the burner. Push the knob for the hob
down and turn it counterclockwise to
the maximum gas flow position .
• For integrated ignition on knob push
the knob for the hob down and turn it
counterclockwise to the maximum gas
flow position .
Keep the knob for the hob pushed for
equal or less than 10 seconds to let the
thermocouple warm up. If not, the gas
supply is interrupted.
Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
If the burner accidentally
goes out, turn the knob to
the off position and try to
light the burner again after
minimum 1 minute.
www.electrolux.com 10