Electrolux EDH903R9WB, Руководство пользователя, Страница: 10 / 56

Symbol on the display Symbol description
-
time drying selection (10min-2h)
-
delay start selection (1h-20h)
5. WI-FI - CONNECTIVITY SETUP
This chapter describes how to connect
the smart appliance to the Wi-Fi network
and to link it to a mobile devices.
By this functionality you can receive
notifications, monitor and control your
tumble dryer from your mobile devices.
To connect the appliance to enjoy the full
range of features and services you need:
• Wireless network at home with
internet connection enabled.
• Mobile device connected to wireless
network.
Frequency 2.4 GHz according to
local country regulation
Protocol IEEE 802.11b/g/n
Max power According to local
country regulation
Minimum requirements:
Operating system
compatibility iOS 9.3/Android
5.1 and above. Install the
Electrolux Life app, create
an account and accept the
Terms and Conditions and
Electrolux's Privacy Policy to
use the connected features.
Stable Internet and good Wi-
Fi connection with 2.4GHz
wireless frequency is
required. Minimum
requirements, apps and
services are subject to
change without notice.
5.1 Installing Electrolux Life
When connecting the tumble dryer to the
application, stand near it with Your smart
device.
Make sure that your smart device is
connected to the wireless network.
1. Go to the App Store on your smart
device.
2. Download and install App Electrolux
Life .
3. Make sure you started a Wi-fi
connection in the dryer. If not go to
the section below.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in
Electrolux Life.
5.2 Configuring the dryer
wireless connection
Have Electrolux Life downloaded and
installed on your smart device.
1. In the App - tap on Add appliance
and follow the instructions on the App
for appliance connection.
2. Press the on/off button for a few
seconds to activate the appliance.
3. Select a programme by turning the
programme dial.
4. Press and hold Remote touch
button for 3 seconds.
The text pop up for about 5 seconds
and the icon starts flashing and
wireless module begins starting up. It
may takes about 45-50 seconds before it
is ready. When the wireless module is
ready, the text
(Access Point) is on
to inform you, that the access point will
be open for about 3 minute.
5. Configure the Electrolux Life app on
your smart device.
6. If the connectivity is configured,
(Access Point) symbol is off and the
icon
will stop blinking and lit
steadily to confirm that the
configuration was successful.
www.electrolux.com 10