10
30” FULL GAS RANGE INSTALLATION INSTRUCTIONS
IMPORTANT SAFETY NOTICE:
Burning gas cook-
ing fuel generates some by-products which are on
the list of substances which are known by the State
of California to cause cancer or reproductive harm.
To minimize exposure to these substances, always
operate this unit according to the instructions con-
tained in this booklet and provide good ventilation.
Propane gas installation
The propane gas tank must be equipped with its
own high pressure regulator. In addition, the regula-
tor supplied with this unit must also be used. The
appliance is shipped from the factory for use with
natural gas. It must be converted for use with pro-
pane. The conversion must be done by a qualified
technician or installer. This appliance has been certi-
fied for safe operation up to a height of 10,000 ft.
Exception: To use it with propane gas, the appliance
must be converted in accordance with the propane
conversion instructions.
For Massachusetts installations:
• Installation must be performed by a qualified or
licensed contractor, plumber or gas fitter qualified
or licensed by the state, province or region where
this appliance is being installed.
• Shut-off valve must be a “T” handle gas cock.
• Flexible gas connector must not be longer than
36 inches.
Installer - show the owner where the gas shut-off
valve is located.
Gas connection
The appliance is shipped from the factory for use
with natural gas at a pressure of 5" of water column.
When checking if the regulator is working properly,
the inlet pressure must be at least 1" greater than
the operating (manifold) pressure above. When
used with natural gas, the pressure supplied to the
regulator must be between 6" and 10.5" of the water
column.
To convert the appliance to propane gas see
"Conversion to Propane gas (LPG)". The conversion
must be done by a qualified technician or installer.
Use a flexible gas pipe with a length of at least 5 ft
(1.5 m). The gas inlet to the unit is located at the
back right of the appliance. Install the pressure
regulator (supplied with the unit) on the gas inlet.
Install the gasket (supplied with the unit) between
the inlet and the regulator. Position the regulator so
that the cap D is easily accessible. Tighten the nut
on the gas inlet so that it is hand tight plus 1/3 turn.
Connect the gas pipe to the regulator using Teflon
tape or pipe-joint compound (resistant to propane
gas and natural gas). Turn so that it is hand tight
plus 1/3 turn. Do not exceed 1 turn for alignment, to
prevent possible damage to the gas pressure
regulator.
1
Gas inlet (attached to the appliance).
2
Gasket.
3
Pressure regulator.
WARNING
State of California Proposi-
tion 65 Warning:
This product may contain a chemical known to
the State of California, which can cause can-
cer or reproductive harm. Therefore, the pack-
aging of your product may bear the following
label as required by California. For more infor-
mation go to www.P65Warnings.ca.gov
CAUTION
Do not allow regulator to rotate on
pipe when tightening fittings.
WARNING
Do not attempt to adjust the pres-
sure regulator, except when converting to propane.
Adjustments could lead to leaks or cause incorrect
gas pressure being supplied to the appliance.
Содержание ECFG3068AS
Страница 63: ...914780107 A 432021 ...
