
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a halogen,
230 V, 25 W, 300 °C heat resistant
lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
11. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
11.1 What to do if...
Problem
Possible cause
Remedy
You cannot activate or op‐
erate the oven. The display
shows “400” and an acous‐
tic signal sounds.
The oven is incorrectly
connected to an electrical
supply.
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
The oven does not heat
up.
The oven is deactivated.
Activate the oven.
The oven does not heat
up.
The clock is not set.
Set the clock.
The oven does not heat
up.
The necessary settings are
not set.
Make sure that the settings
are correct.
The oven does not heat
up.
The fuse is blown.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
The lamp does not oper‐
ate.
The lamp is defective.
Replace the lamp.
Steam and condensation
settle on the food and in
the cavity of the oven.
You left the dish in the
oven for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
There is no good cooking
performance using the Ba‐
kingPlus function.
You did not activate the
BakingPlus function.
Refer to "Activating the Ba‐
kingPlus function".
There is no good cooking
performance using the Ba‐
kingPlus function.
You did not fill the cavity
embossment with water.
Refer to "Activating the Ba‐
kingPlus function".
www.electrolux.com
28