Electrolux 65557 G-M, Инструкция пользователя

Страница: 13 / 21

13
z
The following instructions about
installation and maintenance must be
carried out by qualified personnel in
compliance with the regulation in force.
l
The appliance must be electrically
disconnected before all interventions. If any
electric supply to the appliance is required
to carry out the work, ensure all the
necessary precautions are followed.
l
The side walls of the unit in which the hob
is going to be installed, must not exceed
the height of the working top.
l
Avoid installing the appliance in the
proximity of inflammable materials (e.g.
curtains, tea towels etc.).
THE MANUFACTURER WILL NOT ACCEPT
LIABILITY, SHOULD ANY OF THE OTHER
SAFETY INSTRUCTIONS INCORPORATED IN
THIS BOOKLET OR THE REGULATION IN
FORCE BE IGNORED.
Installation
ramp by means of a threaded nut G 1/2". In-
terpose the sealing between the components
as shown in figure. Screw the parts without
forcing, adjust the connection in the required
direction and tighten everything.
Connection using flexible nonmetal pipes
When the connection can be easily inspected
in its full extent, there is the chance to use a
flexible pipe according to the rules in force.
The flexible pipe must be tightly fixed using
clamps according to the rules in force.
Liquid gas : use the rubber pipe holder « D » .
Always insert the gasket « B ». Then proceed
with the gas connection. The flexible pipe
should be made ready for use in such a way
that:
- nowhere it can reach overtemperature,
other than room temperature, higher than
30°C; if the flexible pipe, to reach the cock,
must run behind the range, it must be
installed as shown in picture;
- it is no longer than 1500 mm;
- it shows no throttles;
- it is not subject to traction or torsion;
- it doesn't get in touch with cutting edges
or corners;
-it can be easily inspected in order to check
its condition.
The control of preservation of the flexible pipe
consistsin checking that:
- it doesn't show cracks, cuts, marks
of burnings bothon the end parts and
on its full extent;
- the material is not hardened, but
shows its normal elasticity;
- the fastening clamps are not rusted;
Choose fixed connections or use a
flexible pipe instainless steel in
compliance with the regulation in force.
If using flexible metallic pipes, be
careful they do not come in contact with
mobile parts or they are not squeezed.
Use the same attention when the hob
is combinated with an oven.
IMPORTANT
-
To ensure a correct operation,
a savingof energy and the long life of the
appliance, the voltage pressure of the
appliance must correspond to the
recommended
values. The adjustable
connection is fixed to the comprehensive
Gas connection