Electrolux 520003, Инструкция по эксплуатации

Страница: 18 / 47

11
Figure 6 Positioning Machine
Figure 7 Unwrapping Packaging Film
•
Be cautious to remove the protective film from
the external plate, but not to be torn, to avoid
adhesive mark remained (Figure 6).
•
Rotate the special adjustable support leg to
adjust the equipment to ensure that it is
longitudinally and transversely kept in a perfect
condition (Figure 8).
Figure 8 Adjusting Supporting Leg
E5 Disposal of Packaging Materials
All the packaging materials are environmentally
friendly. They must be safely stored, recycled, or
sent to a special incinerator for incineration. The
recyclable plastic components are marked as
follows:
Polyethylene: Outer package, pouch
of instruction manuals.
Polypropylene: Top packaging plate,
tie-down straps
Foaming polystyrene: Protective plate
of edges and corners
The wooden materials and cardboards must be
disposed of in line with regulations of the country
where the machine is installed.
E6 Connection of Pump Unit
Important Information!
The watermark label machine must be
installed in accordance with AS/NZS 3500.1.
The water inlet and outlet pipes of the machine
are installed according to the following pipeline
diagrams and installation drawings.
•
Connect the water pipe
“
C
”
(see E6.2
"Installation Drawing")to the manifold. Install
shut-off valve, supplied filter and pressure
gauge between the equipment and manifold.
(
Figure 9)
Figure 9 Connection to Water Inlet Pipe
•
Check the dynamic pressure of water supply.
Measure the pressure between the equipment
and manifold, which should be ranged from 200
to 500 kPa (the test should be performed with
dishwasher water tank or boiler fully filled).
In case of excessively high pressure, install a
proper pressure-reducing valve on the water pipe.
•
Connect the wastewater drain pipe
“
D
”
(see