Electrolux 10 GN 1/1, Руководство пользователя

Страница: 24 / 38

24
2. With the door open, press the two top and bottom retaining
clips as shown in the figure to reach the interspace between
the inner and external glass;
Clean the outer side of the internal glass door using a glass
product;
3. Clean then the interspace surfaces between the doors.
4. Refit the internal glass into the clips and close the oven door.
DOOR AREA
IMPORTANT
It is strongly recommended to clean each day the
area along the entire door perimeter, the rubber
gasket and the internal glass especially near the edge.
After cooking cycle the oven door, its internal glass, the gasket
and the area around the door perimeter may become easily
dirty due to greasy vapours coming out from the oven.
These operations must be done with the door glass cold,
without using abrasive detergents or rags.
1. Clean thoroughly the oven area along the door perimeter as
indicated in the following figure:
2. Clean along the rubber gasket;
EFFICIENCY CONTROL OF THE DISCHARGE SYSTEM
Residues released during cooking, despite regular cleaning of
the cooking chamber, can encrust the external discharge pipe. It
is therefore essential to check the efficiency of the discharge and
to clean the external pipe as soon as there are signs of
obstruction. At least
once a year , clean the drain pipe.
G.3 Boiler maintenance
In case of excessive scale in the boiler the display signals the
need to carry out descaling.
• For boiler descaling see F.8.1 Boiler descaling (dESC)
paragraph.
IMPORTANT
The manufacturer declines any liability if these
prescriptions are not respected;
Also, the warranty does not cover the repair or
replacement of components damaged by scale when-
ever the required supply water characteristics are not
respected.
CLICK !