Electrolux Professional WB6-20, Руководство по установке

Страница: 54 / 72

54
Installation manual
22.3.2 Evacuation duct
It is recommended that a separate smooth walled evacuation duct should be connected to each machine, providing
the least possible resistance to air.
Check that the shaft flow is at least twice the capacity of the gas exchanger draught accelerator.
• Draught accelerator maximum flow rate with no pressure : 260 m 3 /h (152 cfm).
• Maximum pressure available with no flow : 27 mm H
2
O (1″ H
2
O).
• Maximum admissible head loss on evacuation : 15 mm H
2
O (0.6″ H
2
O) at point (P).
• Average temperature of exhaust coming out of the gas exchanger : 140 °C (284 °F).
• Provided an upper ventilation of 7 dm
2 (1.1 sq. ft) and a lower one of 14 dm 2 (1.5 sq. ft) in your laundry.
• For gas heating, the required combustion fresh air supply should be not less than 2 m 3 /h (1.17 cfm) per kW, either
80 m 3 /h (47 cfm) minimum.
These conditions are absolutely essential for the correct working of the machine.
Note!
If the flow is insufficient due to an excessive pressure loss, a safety pressure switch will automatically
switch the heating off.
22.4 Installation of the exhaust of burn gas
Connect the whole set of pipes on your chimney pipe, that is to say.
A Aluminium pipe length 500 mm (20″)
B T-square pipe
C Chimney regulator
D Draught accelerator
Note!
It is necessary to install the gas exchanger at the ground level.
Installation on the left side of the washer (detergent container side) Installation on the right side of the washer (motion side)