30
• clean the cabinet, going over all the stainless steel surfaces
vigorously with a rag moistened with paraffin oil to create a
protective film;
• leave the door or drawers, if present, open so that air can
circulate inside, preventing the formation of unpleasant
odours;
• for the electric heated models: switch on the appliance at
the minimum rate of heat for at least 45 minutes; this will
allow moisture/humidity accumulated into the heating
elements to evaporate without damaging the elements;
• never store the appliance where the temperature can drop
below 0
℃
[32
℉
];
• periodically air the premises.
M
TROUBLESHOOTING
M.1
Introduction
Certain faults may occur during normal use of the appliance. In
some cases, faults can be eliminated easily and quickly by
following the indication below.
The display, if present, could show a warning message
indicating a fault in progress.
If the fault persists, contact the Customer Care Service:
1. Disconnect the appliance from the main power supply;
2. Switch off the safety circuit breaker ahead of the
appliance;
3. Close the gas and water tap(s), if they are present;
4. Remember to specify:
• the type of fault
• the appliance PNC (product number code)
• the Ser. No. (appliance serial number).
IMPORTANT
The appliance PNC and serial number are essential
for identifying the type of appliance and date of
manufacture.
M.2
Troubleshooting
Anomaly
Possible causes
Actions
Water supply
No water is coming into the tank
• The local water tap is off
• The tank’s water tap is blocked
• Open the water tap
• Clean the outlet tap
Digital
Cannot use the appliance
No power from local mains
Switch on the main fuse
E_13
• Overheating fault
• Display
• Ventilator
• Allow to cool
• Clean/unblock vents
• Clean the filter
• Ensure flow of clean air
• If the problem persists, please inform
Customer Care Service
N
APPLIANCE DISPOSAL
WARNING
Refer to “
N.1
Procedure regarding appliance disposal
At the end of the product's life-cycle, make sure it is not
dispersed in the environment.
Different regulations are in force in the various countries,
therefore comply with the provisions of the laws and compe-
tent bodies in the country where appliance disposal takes
place.
The appliance's parts must be disposed of in a differentiated
way, according to their different characteristics (e. g. metals,
oils, greases, plastic, rubber, etc.).
Before disposing of the appliance, make sure to carefully
check its physical condition, and in particular any parts of the
structure that can give or break during dismantling.
Depending on the model, the doors must be removed before
dismantling the appliance.
The symbol on the product indicates that this
product should not be treated as domestic
waste, but must be correctly disposed of in
order to prevent any negative consequences
for the environment and human health. For
further information on the recycling of this
product, contact the local dealer or agent, the
Customer Care service or the local body
responsible for waste disposal.
NOTE!
When dismantling the appliance, any marking, this
manual and other documents concerning the appli-
ance must be destroyed.
