Electrolux Professional N7E, Инструкция по установке и эксплуатации

Страница: 11 / 26

11
• This space must be increased in case of use and/or transfer of other equipment and/or
means or if exit routes are necessary inside the workplace.
A.11 Operating limits
Induction appliances: to guarantee continuous operation at maximum power, the room
temperature must be below 40
℃ .
A.12 Positioning
• Install the appliance, taking all the safety precautions required for this type of operation,
also respecting the relevant fire-prevention measures.
• Handle the appliance with care in order to avoid damage or danger to people. Use a
pallet for handling and positioning.
• The installation diagram gives the appliance overall dimensions and the position of
connections (gas, electricity, water). Check that they are available and ready for making
all the necessary connections.
• Prevent the areas where the machine is installed to be polluted with corrosive
substances (chlorine, etc.). In case such prevention cannot be guaranteed, the entire
stainless steel surface has to be coated by a paraffin protective film spread by using a
rag soaked with paraffin. The manufacturer declines any liability for corrosive effects
due to external causes.
• The appliance can be installed separately or combined only with other appliances of the
same range.
• The appliances are not suitable for recess-mounting. Leave a space of at least 250 mm
between the appliance and side walls and 100 mm from the rear wall, or in any case an
adequate space to enable subsequent servicing or maintenance operations.
• Suitably insulate surfaces that are at distances less than that indicated.
• Maintain a distance of at least 250 mm between the appliance and any combustible
walls. Do not store or use flammable materials and liquids near the appliance.
• Check and, if necessary, level the appliance after positioning. Incorrect levelling can
cause appliance malfunctioning.
• Wear protective gloves and unpack the machine, carrying out the following operations:
– cut the straps and remove the protective film, taking care not to scratch the surface if
scissors or blades are used;
– remove the cardboard top, the polystyrene corners and the vertical protection pieces;
– for appliances with stainless steel cabinet, remove the protective film very slowly
without tearing it, to avoid leaving glue stuck to the surface;
– should this happen, remove the traces of glue with a non-corrosive solvent, rinsing it
off and drying thoroughly;
– go over all stainless steel surfaces vigorously with a cloth moistened with paraffin oil
in order to create a protective film.
• In case of electrical permanent connection: the device must be lockable in the open
position and accessible even after the appliance is installed in its place.
WARNING
Keep the ventilation openings in the appliance casing free of any obstructions.
A.13 Reasonably foreseeable improper use
Improper use is any use different from that specified in this manual. During machine
operation, other types of work or activities deemed improper and that in general can involve