Electrolux Professional A7FTEDCSI0, Руководство по обслуживанию

Страница: 32 / 75

32
FRY TOP 700/900 EL/GAS
2.4 INSTALLATION ACCESSORIES
All documentation for each PNC is available for authorized technicians on the web sites (PRIDE-SERVICE
PORTAL- AGELUX etc..) and can be downloaded in file. For those that do not have access to the web sites,
refer to your local country customer care.
2.5 FIRST START UP
Once that all the supplies connections have been
carried out it’s time to startup the appliance.
Remove the entire protective film from all the panelings and door; the protective film can be easily removed
when the appliance has not been heated up. If the appliance is run for a long period without removing the
protective film the film could melt and then be difficult to remove / damage the panellings finishing.
The top cooking surface must be cleaned from any protective oil residuals, refer to the cleaning instructions at
§
CLEANING .
DAILY STARTUP OF GAS APPLIANCE
All standard appliances can be set G20 (natural gas) or G30/G31 (liquid gas) configuration (nozzels
mounted). Before you turn on the appliance make sure that the power supply or gas type and pressure match
those indicated on the appliance data plate at §
DATA PLATE (IDENTIFICATION STICKER).
2.5.1.1 700 GAS SUPPLIED APPLIANCES
The 700 appliances have a different valve than the 900 and the ignition procedure is different.
To turn on (start) the appliance:
The gas control knob
“A” is located on the control panel and has the following positions:
Ignition (turning ON the appliance)
1.
Press and turn knob “A “ lightly and turn it counterclockwise to release it from the
position
2. Press fully the "A “ knob and turn it into pilot ignition
position; at the same time press the igniter button
“B“ repeatedly until the pilot burner ignites. About 20" seconds after lighting, release knob “A“; the pilot
flame must stay alight.
3 Check the correct ignition of the pilot burner through the
sight hole “C“. If not lit, repeat the operation.
4. Once the pilot is lit, start the appliance by rotating the valve knob to
the position “Temperature”