MENU
VOL
SLEEP
MUTE
QUICK VIEW
CALL
VOL
ENTER
CH
CH
1
2
3
4
5
6
7
0
8
9
–
SET
+
CH.1/2
TV/CAP/
TEXT
RESET
TV/AV
POWER
Wider Hole
and Blade
d. If the unit does not operate normally by
following the operating instructions.
Adjust only those controls that are
covered by the operating instructions, as
an improper adjustment of other controls
may result in damage and will often
require extensive work by a qualified
technician to restore the unit to its normal
operation.
e. If the unit has been dropped or the cabinet
has been damaged.
f.
When the unit exhibits a distinct change
in performance, this indicates a need for
service.
20. REPLACEMENT PARTS-
When replacement
parts are required, be sure the service
technician uses replacement parts specified
by the manufacturer or those that have the
same characteristics as the original part.
Unauthorized substitutions may result in fire,
electric shock or other hazards.
21. SAFETY CHECK-
Upon completion of any
service or repairs to this unit, ask the service
technician to perform safety checks to
determine that the unit is in proper operating
condition.
22. HEAT-
The product should be situated away
from heat sources such as radiators, heat
registers, stoves, or other products (including
amplifiers) that produce heat.
23. NOTE TO CATV SYSTEM INSTALLER-
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC that provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the
grounding system of the building, as close to
the point of cable entry as practical.
12. POWER-CORD PROTECTION-
Power-
supply cords should be routed so that they
are not likely to be walked on or pinched by
items placed upon or against them, paying
particular attention to cords at plugs,
convenience receptacles, and the point
where they exit from the appliance.
13. LIGHTNING-
To protect your unit during a
lightning storm, or when it is left unattended
and unused for long periods of time, unplug it
from the wall outlet and disconnect the
antenna or cable system. This will prevent
damage to the unit due to lightning and
power line surges.
14. POWER LINES-
An outside antenna system
should not be located in the vicinity of
overhead power lines, or other electric light
or power circuits, or where it can fall into
such power lines or circuits. When installing
an outside antenna system, extreme care
should be taken to keep from touching such
power lines or circuits as contact with them
might be fatal.
15. OVERLOADING-
Do not overload wall
outlets and extension cords as this can result
in a risk of fire or electric shock.
16. OBJECT AND LIQUID ENTRY-
Do not push
objects through any openings in this unit as
they may touch dangerous voltage points or
short out parts that could result in fire or
electric shock. Never spill or spray any type
of liquid into the unit.
17. OUTDOOR ANTENNA GROUNDING-
If an
outside antenna or cable system is con-
nected to the unit, be sure the antenna or
cable system is grounded to provide some
protection against voltage surges and built-up
static charges. Section 810 of the National
Electrical Code, ANSI/NFPA 70, provides
information with respect to proper grounding
of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connec-
tion to grounding electrodes, and require-
ments for the grounding electrode.
18. SERVICING-
Do not attempt to service this
unit yourself as opening or removing covers
may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified
service personnel.
19. DAMAGE REQUIRING SERVICE-
Unplug
this unit from the wall outlet and refer
servicing to qualified service personnel under
the following conditions:
a. When the power-supply cord or plug is
damaged.
b. If liquid has been spilled, or objects have
fallen into the unit.
c. If the unit has been exposed to rain or water.
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within
the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock.
9. VENTILATION-
Slots and openings in the
cabinet back or bottom are provided for
ventilation, to ensure reliable operation of the
unit and to protect it from overheating. These
openings must not be blocked or covered.
The openings should never be blocked by
placing the unit on a bed, sofa, rug, or other
similar surface. This unit should never be
placed near or over a radiator or heat source.
This unit should not be placed in a built-in
installation, such as a bookcase, or rack
unless proper ventilation is provided or the
manufacturer's instructions have been
adhered to.
10. POWER SOURCE-
This unit should be
operated only from the type of power source
indicated on the rating plate. If you are not
sure of the type of power supply to your
home, consult your appliance dealer or local
power company. For units intended to
operate from battery power, or other sources,
refer to the operating instructions.
11. GROUNDING OR POLARIZATION-
This
unit is equipped with a polarized alternating
current line plug (a plug having one blade
wider than the other). This plug will fit into the
power outlet only one way. This is a safety
feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If
the plug still fails to fit, contact your electri-
cian to replace your obsolete outlet. Do not
defeat the safety purpose of the polarized
plug. If your unit is equipped with a 3-wire
grounding-type plug, a plug having a third
(grounding) pin, this plug will only fit into a
grounding-type power outlet. This too, is a
safety feature. If you are unable to insert the
plug into the outlet, contact your electrician to
replace your obsolete outlet. Do not defeat
the safety purpose of the grounding-type plug.
1. READ INSTRUCTIONS-
All the safety and
operating instructions should be read before
the unit is operated.
2. RETAIN INSTRUCTIONS-
The safety and
operating instructions should be retained for
future reference.
3. HEED WARNINGS-
All warnings on the unit
and in the operating instructions should be
adhered to.
4. FOLLOW INSTRUCTIONS-
All operating and
use instructions should be followed.
5. CLEANING-
Unplug this unit from the wall
outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp
cloth for cleaning the exterior cabinet only.
6. ATTACHMENTS-
The manufacturer of this
unit does not make any recommendations for
attachments, as they may cause hazards.
7. WATER AND MOISTURE-
Do not use this
unit near water. For example, near a bathtub,
washbowl, kitchen sink, laundry tub, in a wet
basement, or near a swimming pool.
8. ACCESSORIES-
Do not place this unit on an
unstable cart, stand, tripod, bracket, or table.
The unit may fall, causing serious injury, and
serious damage to the unit.
8A.
An appliance and cart combination should be
moved with care. Quick stops, excessive
force, and uneven surfaces may cause the
appliance and cart combination to overturn.
REMOTE CONTROL
Before using the remote control transmitter, batteries must first be installed.
2. Install two "AAA" batteries.
3. Replace the battery compartment cover.
Use two "AAA" batteries (not supplied) for the
transmitter. The batteries may last
approximately one year depending on how
much the remote control is used. For best
performance, it is recommended that batteries
should be replaced on a yearly basis, or when
the remote operation becomes erratic. Do not
mix old and new batteries or different types.
BATTERY PRECAUTIONS
These precautions should be followed when
using batteries in this device:
1. Use only the size and type of batteries
specified.
2. Be sure to follow the correct polarity when
installing the batteries as indicated in the
battery compartment. Reversed batteries
may cause damage to the device.
3. Do not mix different types of batteries
together (e.g. Alkaline and Carbon-zinc) or
old batteries with fresh ones.
4. If the device is not to be used for a long
period of time, remove the batteries to
prevent damage or injury from possible
battery leakage.
5. Do not try to recharge batteries not intended
to be recharged; they can overheat and
rupture.
(Follow battery manufacturer's directions.)
1. Open the battery compartment cover.
HOW TO INSTALL BATTERIES
TO USE AC POWER SOURCE
Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a
standard 120V 60Hz polarized AC outlet.
POWER SOURCE
NOTES:
1. Never connect the AC line cord plug to other than the
specified voltage (120V 60Hz). Use the attached
power cord only.
2. If the polarized AC cord does not fit into a non-
polarized AC outlet, do not attempt to file or cut the
blade. It is the user's responsibility to have an
electrician replace the obsolete outlet.
3. If you cause a static discharge when touching the unit,
and the unit fails to function, simply unplug the unit
from the AC outlet, wait a few minutes, and plug it
back in. The unit should return to normal operation.
Polarized AC Cord Plug
(One blade is wider than
the other)
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions
in the literature accompanying the appliance.
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
NEC-NATIONAL ELECTRICAL CODE
S2898A
AC Outlet
IMPORTANT SAFEGUARDS
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL.
S3126A
PORTABLE CART WARNING
(symbol provided by RETAC)
GROUND CLAMP
ELECTRIC
SERVICE
EQUIPMENT
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
ANTENNA LEAD IN WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING
CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
After the sleep time is programmed,
the display will disappear then reappear
momentarily every ten minutes to remind
you the sleep timer function is operating.
To confirm the sleep time setting, press
the SLEEP button once and the remaining
time will be momentarily displayed. To
cancel sleep time, press the SLEEP button
repeatedly until the display turns to 0.
VOL (VOLUME)
/
Buttons -
Press the
button to increase, or the
button to
decrease the volume level.
MENU Button -
Press to display the On-
Screen menu function.
SET – / + Buttons -
Press to select the
desired setting during On-Screen operations.
RESET Button -
Press to reset the On-
Screen picture adjustments to their
factory preset positions.
TV/AV Button -
Switches between TV and
external inputs.
CALL Button -
When you press this
button, the channel number will appear on
the upper right corner of the screen. Press
the button again to remove display from
the screen.
MUTE Button -
To turn off the sound,
press this button once. The TV will be
silenced and the symbol "MUTE" will
appear on the screen. The mute feature
can be released by pressing the MUTE
button again or one of the VOL
or
buttons.
CH (CHANNEL)
/
Buttons -
Press
the
button to change to a higher
numbered channel set into memory. Press
the
button to change to a lower numbered
channel set into memory.
ENTER Button -
Press to enter or select
information for On-Screen operations.
TV/CAP/TEXT Button -
Press this
button to switch between normal TV
and the two Closed Caption modes
(captions and 1/2 of full screen text).
Closed Captioning will display text on
screen for hearing impaired viewers.
CH.1/2 Button -
Switches between
Channel 1 and Channel 2 in the Closed
Caption mode.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1.
2.
3.
4.
POWER Button -
Press to turn the TV on.
Press again to turn the TV off.
Direct Channel Selection Buttons (0-9) -
Allows direct access to any channel.
QUICK VIEW Button -
This button allows
you to go back to the previous channel
selected by just pressing the QUICK VIEW
button. Press this button again to return to
the channel you were watching.
SLEEP Button -
To set the TV to turn off
after a preset amount of time, press the
SLEEP button on the remote control.
The clock will count down 10 minutes
each time the button is pressed in the
order of 120, 110, 100, ······ 20, 10, 0.
1
2
3
5
6
7
8
9
10
11
12
13
15
4
14
WARNING :
CAUTION :
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
TO PREVENT ELECTRIC SHOCK DO NOT USE THIS POLARIZED PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT
BLADE EXPOSURE.
3Q60421A E
3/8/05, 4:13 PM
3
