Electro-Voice PX-D1 Скачать руководство пользователя страница 1

Phoenix Series

Accessories

User Instructions

Figure 1: 

Assembling the PX-D1 to a Phoenix

PX2122 or PX2152 Loudspeaker

PX-D1

The Electro-Voice® PX-D1 accessory consists of a pair of dolly plates with assembled casters for use with the Phoenix
PX2122 and PX2152 Loudspeakers.  Each dolly plate is capable of rotating out of the way when the dolly is not in use.  This
is especially useful for when the speakers are being shipped or arrayed, whether on a groundstack or hanging from a grid.

1.  Remove (2) 5/16” bolts from rear of the PX2122 or PX2152 enclosure.
2.  Align the plastic standoffs with the recesses in the enclosure so the dolly board is perpendicular to the length of
    the enclosure.  Turn the wing screw into the enclosure until tight (see Figure 1).
3. When not being used for transport, rotate the dolly boards so they are parallel to the length of the enclosure.
    Loosen the wing screw until the dolly board is able to rotate freely.  Turn the dolly board 90°, and tighten the wing
    screw (see Figure 2).

Figure 2: 

Rotating the PX-D1 on the rear of a

Phoenix Loudspeaker for shipping or arraying

Remove Existing

Screws, Install

Dolly Plates, then

Attach Wing

Screws (2 Places)

Loosen Wing

Screws, Rotate and

Align Grooves, then

Re-attach Wing

Screws

CAUTION!  If the dolly boards are removed, replace the (2) 5/16” bolts into the rear of the
enclosure. If the bolts are not replaced, the speaker will have air leaks resulting in undesirable
performance.

Отзывы: