U.S.A. and Canada only. For customer orders,
contact the Customer Service department at
800/392-3497 Fax: 800/955-6831
Europe, Africa and Middle East only. For customer orders,
contact the Customer Service department at
49 9421-706 0 Fax: 49 9421-706 265
For warranty information, contact the Service Repair department at:
616/695-6831 or 800/685-2606
For technical assistance, contact Technical Support at:
866/78AUDIO
Specifications subject to change without notice.
12000 Portland Avenue South, Burnsville, MN 55337
Phone: 952/884-4051, Fax: 952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 12/2005
Part Number 38110-518 Rev 2
CA-ZX (P/N 302023-001)
1. Screw the truss clamp onto the pole mount spigot, using an adjustable wrench (Figure 1).
2. Turn the ZX1-90 enclosure upside down, and remove the setscrew from the back of the pole mount (Figure 2).
3. Insert the truss clamp and pole mount spigot into the pole mount on the ZX1-90 (Figure 3). Screw the eyebolt into the
back of the pole mount. Test that the eyebolt is located in the groove of the spigot properly by pulling on the truss
clamp, tighten eyebolt.
4. Mount the truss clamp to the truss (Figure 4).
Securely tighten the clamp.
Attach a cable (not included) to the
eyebolt and truss as a safety precaution.
Figure 1:
Screw Truss Clamp to Pole Mount
Spigot
Figure 2:
Removing Setscrew from Back of Pole
Mount
Figure 3:
Attaching Clamp and Spigot to Pole
Mount on Bottom of Enclosure
Figure 4:
Mounting Truss Clamp to Truss
User Supplied
Safety Cable