6.
Insert one M6 screw (supplied) into each mount at the desired angle.
7.
Tighten the two M6 screws (supplied) sufficiently so the loudspeaker does not rotate.
The loudspeaker is set to the desired angle.
Eyebolt kit
The EBK1-M10 Eyebolt Attachment Kit from Electro-Voice is designed exclusively for ELX200
full-range loudspeakers, for ease of installation. It contains three short shank shoulder
eyebolts, along with four washers for load distribution, which attach to Electro-Voice
loudspeakers that have integrated M10 suspension points. The eyebolt attachment points can
be used to suspend Electro-Voice loudspeakers using hardware rated for overhead lifting. The
loudspeaker is suspended using two main suspension points with one pull-up point in the
back for aiming. Rigging hardware (shackles, etc.) attaching to the eyebolt must fit through
the 25 mm (1 in) opening.
The eyebolt kit contains the following:
Quantity
Component
3
M10 x 20 mm (0.787 in) short shank shoulder eyebolts
4
M10 (10.5 mm ID x 20.0 mm OD) washers
1
Datasheet
Table 2.2: Eyebolt kit components
Notice!
Extra washer provided for leveling of uneven surfaces. ELX200-10/10P may require additional
washer.
2.2
en
11
Electro-Voice
Installation note
2017.12 | 02 | F.01U.332.445