- FCC COMPLIANCE -
Note:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
.
Modifications not expressly approved by the manufacturer could void the user's authority to
operate the equipment under FCC rules.
.
45000 FOOT CONTROLLER
Remote Foot Controller for 45000
Congratulations! You have just purchased the
45000 FOOT CONTROLLER
from
Electro-Harmonix! The 45000 Foot Controller is a wired remote control for the 45000
Looper, giving your feet direct access to the following controls: Track Select, Record,
Play, Loop Up and Loop Down.
The 45000 Looper records and plays back up to 100 loops per SDHC card. The 45000
Foot Controller makes it very easy for your feet to navigate through your 100 loops,
moving up or down through loops by 1 or 10 at a time; allowing you to seamlessly
change loops while playing back. Additionally, the 45000 Foot Controller contains a
large dual-digit LED display to clearly indicate your current or next loop at all times.
- GETTING STARTED -
Connect the 45000 Foot Controller (45000 FC) to your 45000 main unit using a
standard 1/4” mono instrument cable. Plug into the jack labeled FOOT CONTROLLER
on the 45000 Looper. The other end of the cable should be inserted into the 45000
FC’s jack labeled INPUT. As long as the 45000 main unit is powered up, the digits on
the 45000 FC will light up indicating it is ready for use.
- DISPLAY AND FOOTSWITCHES -
2-DIGIT LED DISPLAY
– shows the currently loaded or selected loop number in
the 45000 main unit. The numbers range from 00 to 99. If a loop number contains
audio on the SDHC card, the rightmost decimal point on the 45000 FC will light. If the
rightmost decimal point is not lit, then that particular loop number is empty.
LOOP UP/DOWN Footswitches and LEDs
– Pressing the LOOP UP footswitch will
increment the loop number by 1. Press the LOOP DOWN footswitch to decrement the
loop number by 1. Press and hold either footswitch for approximately half a second to
jump up or down by ten loops at a time instead of just one.
Important:
The Electro-Harmonix 45000 Foot Controller obtains all of its
power from the 45000 Multi-Track Looping Recorder. Use only a standard
¼” guitar cable to connect the Foot Controller to the 45000. A standard
guitar cable has Tip and Sleeve conductors. The Foot Controller does not
require batteries or an AC Adapter.
