Page 8 of 14
OPERATION
When first plugged in the unit will automatically enter standby mode.
ON/OFF
button: Press to turn the unit on and enter cooling mode. The unit will default to cooling mode
with a desired temperature of 22⁰C. Press again and the unit will switch off.
MODE BUTTON
: Press this button to change between Cooling, Fan and Dry Modes.
FAN BUTTON
FAN AND COOL MODE:
Press to change between the available fan speeds.
DRY MODE:
The fan is set to low speed and cannot be changed
TIMER
: The timer functions cannot be combined or repeated.
POWER ON TIMER
With the appliance in standby, press the “TIMER” button to setup the power-on time.
Press the UP and DOWN buttons to adjust the duration of the timer (from 1 to 24 hours). Timer
indicator turns on. The unit will start after selected number of hours.
POWER OFF TIMER
With the appliance running with the desired settings, press the “TIMER” button to setup the
power-off timer. Press the UP and DOWN buttons to adjust the duration of the timer (from 1 to 24
hours). The timer indicator will illuminate. The unit will stop after selected number of hours.
UP
AND DOWN
BUTTONS
: Press to adjust the desired temperature and timer. In cooling mode,
the temperature can range from 16 -
31⁰C.
Press the UP and DOWN buttons together to change between ⁰C and
℉
.
SLEEP MODE BUTTON
:
While in cool mode press
the “SLEEP” button to put the unit in sleep mode. The fan speed will change to
low. It will automatically increase the desired room temperature by 1
℃
after an hour and by a further 1
℃
after a further hour. This means the unit will spend less time with the compressor running, and so run
quieter.
The sleep function cannot be used in dry and fan modes.
If the water tank is filled, the unit is put into standby or the mode is changed, sleep mode will be
cancelled.
