42
EM-TL01-J
OWNER’S MANUAL
2014
change) direction
4, 1
●●●● ●
Over voltage at
startup or
regeneration
Motor drive is disabled if an over-voltage is detected at start-up or
during regeneration.
The voltage threshold detection level is set during configuration.
4, 2
●●●● ●●
Hall sensor signal
error
1.
Incorrect hall wiring, wrong pin or loose wire.
2.
Intermittent or damaged hall sensor.
3.
Incorrect hall angle configuration (60 or 120 degree)
4, 3
●●●● ●●●
Motor over-
temperature
1.
The motor temperature has exceeded the configured maximum.
The controller will shut down and wait for motor temperature
dropping.
2.
Can change the temperature setting with configuration program.
4, 4
●●●● ●●●●
Motor locked rotor
When in locked rotor condition, the max output phase current of the
motor will be limited to 90% of previous current.
Once the problem disappears the fault will clear and the max output
phase current will return to normal.
The RED Led flashes once at power ON as a confidence check then keep off for normal operation.
“1, 2” means the red flashes once then flashes twice after 1 second.
The time between 2 flashes is 0.5 second. The pause time between multiple flash code groups is 2
seconds.
23.
TIGHTENING TORQUE
It had better to respect the tightening torque because it can affect your safety:
Significant screwing can damage screws, and breaking them;
Light screwing can lead to unscrewing them.
ELEMENTS
THREADING
TIGHTENING TORQUE
ON THE
THREADING
Rear suspension/ Frame
M10
40 Nm
Normal LOCTITE
Rear wheel axle
M17
60 Nm
Copper grease
Front wheel axle
M14
30 Nm
Copper grease
Lower part of rear suspension
M10
40Nm
Swingarm / axle
M14
40 Nm
Normal LOCTITE
Clamping of the upper wrown fork on
the pivot
M8
17 Nm
Copper grease
Transmission cover / Transmission
support
M5
4 Nm
-
Plug 120 A / Frame
M5
3 Nm
-
Crown
M8
23 Nm
Normal LOCTITE
Rear and Front disc
M6
12 Nm
Normal LOCTITE
Steering pivot Nut
M18
20 Nm
Copper grease
Front caliper
M8
24 Nm
Copper grease
Front Mudguard / Support mudguard
M6
10 Nm
-
Rear main cylinder / Frame
M6
10 Nm
-
Engine / Transmission support
M8
18 Nm
Normal LOCTITE
Rear brake lever
M8
24 Nm
-
Transmission support / Frame
M8
20 Nm
-
Содержание EMTL01-J
Страница 1: ...EM TL01 J OWNER S MANUAL 2014 1 OWNER S MANUAL...
Страница 44: ...EM TL01 J OWNER S MANUAL 2014 44 25 ELECTRICAL WIRING SCHEMA OF HOMOLOGATED MOTORCYCLE...
Страница 45: ...45 EM TL01 J OWNER S MANUAL 2014 26 SCHEMA HOMOLOGATED ELECTRIC WIRING...
Страница 46: ...46 EM TL01 J OWNER S MANUAL 2014 27 MAIN ELECTRICAL WIRING...