ELECTRIC MOTION EMTL01-J, Руководство пользователя

Страница: 22 / 48

22
EM-TL01-J

OWNER’S MANUAL

2014
6. FORK EM5.7
The 2 tubes are similar; they are each composed of hydraulic and spring system.
Adjustment doesn’t exist in this fork.
Carry out the fork venting regularly, to conserve the technical specifications
Unscrew the screw with a flat screwdriver on the top of the inner tube to allow escape the air. And screw again
after.
FORK OIL CHANGE
Take off the wheel, and the fork of the fork crown.
① Unscrew the cap with key 24 mm on the top of each fork;
② take off spacer and spring in the fork;
③ Pump to empty oil in a container;
V
Collect the oil to bring in a recycling center to reduce the environmental
impact.
④ Fill the fork with: 310 mm of oil (SAE 5), or Bring the oil level up to the
appropriate level:
The oil level suitable 260 mm from the top edge of the tube;
⑤ Re-insert spring and spacer;
⑥ Screw the cap on the top of the fork.
Assembly the forks in the crown at the same height, and assembly the wheel.
Figure 11 : Position of venting screw.
Figure 12 : Oil level
260 mm
Huile SAE 5