Page 8 of 12
2.
3.
1.
2.
3.
4.
Save your settings and upload the configuration to your device
Cellular Host Configuration (GSM, AT&T)
For GSM connections, the RediLink and RediGate 100 series products use standard (also known as "mini") SIM cards. The steps below show
how to install the SIM card:
Remove power and all connectors from the front panel. Remove the two mounting screws from either side of the front faceplate
Gently slide the board out of its enclosure to expose the SIM card slot
Fully insert the SIM card into the SIM card slot, with the metal contacts facing down and the angled edge facing out
Gently slide the board back into its housing and carefully replace the two mounting screws to avoid over-tightening. Replace all front
panel connectors.
The main action required for configuring a GSM RediGate is to set the APN, which is done under the "CellModem" object in your ACE
configuration:
DHCP
If you would like your Ethernet port to obtain its address via DHCP, enter 0.0.0.0 for the Network Card IP, Subnet Mask, and
Default Gateway