ElDorado OUTDOOR LIVING PRODUCTS 200, Руководство по установке

Страница: 1 / 9

pg. 1
OLP Gas Fireplace Installation Guide
Models 200,300,301,302 & Labor Saver Fireplace
Personnel
Required
- (2) Minimum (4) Recommended
Tools
- (2) ¾” box wrenches or sockets
Razor Knife
CAUTION – DO NOT UNPACK IF YOU SEE ANY POSSIBLE SHIPPING DAMAGE!
CALL 800-925-1491
CAUTION – DO NOT DRAG OR SLIDE FIREPLACE SECTIONS – DOLLY OR HAND CARRY
ALL FIREPLACE COMPONENTS
STEP #1 – Unpacking
a. Begin by identifying the 3 interior “fire box” panels. Panels will be wrapped to one side of the entire
package. Use Razor knife to cut away packing material and place panels in a safe place for later
installation.
CAUTION – Packing material may be used to hold panels in place. Careless removal of packing material
may result in damaged panels. TIP Remove one panel at a time while a second person holds remaining
panels in place.
b. Remove the “chimney” section which is packaged on top.
c. With one person on each side, lift section 6 inches then remove and set aside for later installation.
d. Move the base of the fireplace out 3-4 inches away from the center section.
CAUTION – A fourth interior panel is located in a fold of cardboard between the fireplace base and the
center section. Locate and remove this panel immediately and set aside to prevent damage.
Step # 2 – Fireplace Base and Center Section Installation
Fireplace must be placed on solid flat surface, ex. concrete slab, pavers or stone deck.
NOTE – Rear of fireplace must be placed a minimum of 6” away from combustible materials.
DO NOT place
combustible materials within 3’ of firebox opening. DO NOT place fireplace under overhead combustible areas.
a.
Position base of fireplace in desired location.