Adjustment of timers for additional heating with Heat Pump and / or Electric Heater
(Menus
Timers 1
and
Timers 2
)
-
Time intervals in which additional heating is allowed by means of the heat
pump and / or the electric heater. When a timer is active and the current moment is within its range,
the heat pump and / or the electric heater will switch on to heat the water by using the temperature
set in column "
Temp
" for a set temperature and switching on will occur if the temperature of the
lower Sensor 1 drops by 5 ° C below the temperature in “
Temp
”.
WARNING!
The timer allows you to exclude some days of the week during which it will not
work. This is done by darkening the glowing green LEDs
1
-When checked, the timer will work;
2-
Select on which days of the week the timer will be active.
Illuminated diode - on, darkened - off. When the diode is marked, its status changes with the Enter
button;
3-
Days of the week
WARNING!
The time in the column "
Begin
" can not be later than the time in the column "
End
"!
So you may have to change the time in the column "
End
" first and then in the column "
Begin
"!
If hot water is needed only at a particular time of day, in order to achieve a significant reduction in
electricity costs, a low temperature can be set from the "
Temperature Setting
” and only in the
required time intervals via the timer to switch on the heat pump
forcedly and / or the electric heater. If the solar installation is
sufficiently heated by then, the heat pump and / or the heater
will not turn on. At the same time, if the alternative energy is
insufficient, the heat pump and / or the heater will be switched
on to provide the hot water needed!
Pumps control
(only for NHPC-V4-2). Adjustment of the
differential temperatures between the solar collector and the
boiler for switching on and off the pump. At temperature
difference above the value in column
On
the pump will turn on
and will work until a difference is reached below the value in
the column
Off
Heat sources
– place a check for each heat source with which
the water heater works. If you do not have yet a solar collector
installation, you can also turn off the service from this menu (if
the purchased water heater is with a heat exchanger). In
addition, in order for the water heater not to use additional
electricity through the electric heater, you can also deactivate
it. We recommend that you do not change the setting on which
sensor to control the heating with the heat pump.
WARNING!
If the solar collector is deactivated, the anti-freeze
or overheat protection modes will also stop!
29
