ATTENTION!
The water heater is intended for domestic use only, in the household and
serves to heat water from the common water supply network
which
composition and
indicators are within the scope of the water legislation related to the regulations.
ATTENTION!
The water heater must be installed and used according to the requirements of
this instruction only in non-freezing
areas
with normal fire safety and under conditions
corresponding to the degree of protection against water penetration. Otherwise, it will
cause a defect in the appliance, which may constitute a hazard and which, due to failure to
comply with this installation and use instruction, will not be covered by the manufacturer or
the
dealer
warranty obligations.
ATTENTION!
The installation of the water heater and its connection to the
water supply
system shall only be carried out by qualified persons in accordance with the instructions in
this booklet and the current local regulations. The water pressure in the water main must be
not less than 0.2 MPa and not more than 0.8 MPa. It is imperative to install the safety and
other accessories supplied by the manufacturer or recommended by the manufacturer!
WARNING!
The water-heaters of the "
B
eta" family have an open outlet to the atmosphere
and
it is
strictly FORBIDDEN to connect to their outlet pipe
any
stop valve! Failure to do so
will cause the appliance to be destroyed!
WARNING!
It is forbidden to use fittings attached to the outlet pipe (outgoing hoses,
distributor, winch, etc.) which are not provided by the manufacturer or are not in agreement
with the manufacturer.
WARNING!
It is forbidden to install the appliance so that it operates under pressure!
WARNING!
Installing a hand shower different from that provided by the manufacturer is
forbidden because it may impair the functionality and safety of the appliance! Only place a
hand shower provided by the manufacturer and never install an additional water flow limiter.
WARNING!
It is
FORBIDDEN to
block the pipe opening, which drains the water from the
safety valve of the appliance. Fig. 5.
ATTENTION!
Connection of the water heater to the power supply network should be
performed only by qualified persons in accordance with the instructions in present manual
and local regulations in force. The appliance should be properly connected to the current-
carrying wires and the protection grid! DO NOT connect the appliance to the electrical
installation before filling its water tank up completely with water! Failure to comply shall
make the appliance dangerous and in such state its use is strictly forbidden!
WARNING!
IT IS MANDATORY to connect the power cord of the "Beta 4" water heater to
ONLY straight and properly, including protectively
connected
contact
with protective plates
EN
KEY SAFETY REQUIREMENTS
Before starting the installation of your appliance and its operation it
is compulsory to read carefully the text of the instructions booklet.
It is designed to familiarize you with the unit, with the rules for its
proper and safe use and the minimum activities necessary to
maintain and service it. Furthermore, you will need to provide this
guide for use by qualified persons who will install and repair the
unit in case of malfunctioning. Installation and commissioning of
the unit is not a warranty obligation of the seller and/or
manufacturer.
Keep this guide in a suitable place for future reference.
Compliance with the rules helps for safety use of the appliance and
is one of the warranty terms and conditions.
3
WARNING! Before installation and operation with the appliance, read carefully the
present manual!
EN
Содержание 72485 Beta 4
