Elcon Elconnect Fiber FOS 100w, Краткое руководство по эксплуатации

Страница: 19 / 28

FOS 100w
Version: 2010/08/13
17
Pin assignment of the RJ11 socket ( )
1 free
2 free
3 La (Line a to the a/b-interface of the subscriber line)
4 Lb (Line b to the a/b-interface of the subscriber line)
5 free
6 free
Figure 5: Pin assignment of the RJ11 socket
LED signalling
The modem has 5 LEDs which signal the power supply status and data transfer activities.
LED „PWR“ (green): Power supply status
ON Supply voltage applied
OFF No supply voltage applied
LED „WLAN“ (green): WLAN status
ON WLAN activated
OFF WLAN deactivated
LED „LINK“ (green): Access network status
ON Connection to Access Switch established
FLASHES (discontinuously) in line with the bit clocking sequence
FLASHES (at 1 Hz) Booting procedure or no link to the Access
Switch (line interrupted, attenuation too high)
LED „
1
“, „
2
“ (green): Status of the two analogue interfaces
ON SIP-registration executed correctly, receiver hung
up (on-hook
FLASHES (at 4 Hz) SIP-registration is missing
FLASHES (at 1 Hz) Telephone or other terminal unit is ringing
OFF Receiver removed (off-hook)); no user configured
by provider
2.5 Cable connection
1. Link the FOS 100w with the network interface card of the PC. For this, use an
Ethernet cable and connect it to one of the „LAN“-marked RJ45-sockets on the
FOS 100w and to the RJ45-socket of the network interface card (see the related in-
structions).
2. Your analogue telephones, fax equipment, answering machines, tariff metering appli-
ances, etc. shall be connected to one of the RJ11 sockets that are marked with the
symbol „
“.