Elcon Elconnect Fiber FOS 100w, Краткое руководство по эксплуатации

Страница: 20 / 28

FOS 100w
Version: 2010/08/13
18
3. Finally use the enclosed plug-in power supply module to connect the socket „12V
DC“ on the FOS 100w to the electricity network. Do not use any other power supply
module than the one included in delivery. The use of other power supply units will re-
sult in the loss of the CE conformance and exclude any warranty claims.
2.6 Putting into operation
After application of the supply voltage and performed self-configuration the FOS 100w is
ready for work. The complete line between Access Switch and FOS 100w will be put into
operation by the network provider. It has a preset configuration or makes the required settings
automatically by self-configuration.
Prerequisite for proper operation of your data link via the FOS 100w is the correct installation
of the network interface card to your PCs. Detailed information on this should be received in
the documentation provided by the card manufacturer. Further questions about configuration
of your PC should be addressed to your Internet Service Provider.
2.7 Restart and Factory Reset
In case you find the FOS 100w in an undefined operating state (e.g. when no data transfer is
possible), just press the Reset button on the right side of the casing with a pointed tool for a
short moment. If you do not succeed, please contact your Internet service provider. Pressing
the reset button for more than 10 s will cause a factory reset of the device, whereby all locally
performed settings will be reset to the default configuration. A Factory Reset should only be
realized by experienced users. Some settings (e.g. disabled firewall) may result in complete
non-functionality of the FOS 100w!
2.8 Activation / Deactivation of WLAN
Upon initial start-up of the device the WLAN is automatically deactivated as well. The
WLAN status LED does not shine. The WLAN can be activated by keying the WLAN button
placed on the right side of the housing below the reset button. Make sure to not confuse the
buttons with each other, as this could trigger a restart of the FOS 100w.
The WLAN Status LED starts flashing, upon successful activation this LED will then shine
permanently.
By pressing the WLAN button a second time, the WLAN module will be deactivated again.
The current status is indicated through the WLAN status LED.
In default state your FOS 100w has been preset as Access Point with below parameters:
•
Channel: 6
•
SSID: see label
•
Security setting: WPA2/PSK
•
Code: see label
•
Transmit power: 100%