Elbur PB 636 IV, Инструкция по эксплуатации

Страница: 20 / 36

PB 636 IV
Elbur sp. z o.o. sp.k. 20 of 36
•
align holes in holders and the drive,
• insert the quick-release bolt and secure by closing the retainer,
• align holes in the second holder and the drive on the other its end,
• insert the quick-release bolt and secure by closing the retainer.
6.7. Connecting electric components
Warning
Risk of short-circuit and fire – always check are cables in the correct
position. Jamming or kinking of the cable must be avoided.
Plug the electrical component’s plug s into the sockets as shown on the
information label illustrated below (it is also placed inside the control box):
•
1 – mattress support platform drive unit – adjustment of head rest
section,
•
2 – unused connection slot (insert blind stoper),
•
battery charging symbol – unused connection slot
(insert blind stopper),
•
3 – mattress support platform drive unit –
adjustment of foot rest section,
• 4 – lifting drive unit – up and down mattress
support platform adjustment,
•
Hand switch has to be connected to the slot
placed below other slots.
6.8. Cable routing
Warning
Pay special attention to securely placing all cables and wirings. Make sure
they will not be stretched, driven over or damaged by moving parts.
The power cable holder is located on the mattress
support platform on the foot section and head section.
The power supply cord has to be secured in the power
cable holder, otherwise it might be damaged by
stretching, running over or squeezing.
There are holders for hand switch cable on both sides
of the mattress support platform (in the non-moving
section). Please use one on the side, where hand switch
is going to be hooked.