Elbur PB 636 IV, Инструкция по эксплуатации

Страница: 12 / 36

PB 636 IV
Elbur sp. z o.o. sp.k. 12 of 36
If the nursing bed is not going to be used for a while or before relocating
it, always make sure that the power supply cord is unplugged from the
mains supply and make sure that is not stretched, rolled over or damaged
in any other way.
Make sure that no cable is damaged, that there is no loop in the cables
and that they are not crushed by moving parts of the bed or components
of other devices.
Make sure that hand switch is placed properly, that it is not trapped
between side rails and mattress support platform/other furniture.
It is essential to leave the nursing bed unused for at least 18 minutes,
after maximum period of operation of 2 minutes, which must not be
exceeded.
At the same time only one person can operate the bed. It is strictly
prohibited to press all buttons simultaneously on the hand switch.
Do not allow electric components to contact with water – the electrical
components must not be cleaned with a water jet or a high-pressure
cleaner. Clean only with a moist towel.
2.3.3. Information for care personnel
Warnings
Do not perform medical operation on the nursing bed.
Do not use the nursing bed close to equipment generate high
electromagnetic field.
Make sure that patient cannot be trapped between mattress support
platform and side rails
– use special equipment for patient outside
the standard range of build.
Lower the mattress support platform to its lowest position when leaving
patient unattended. It also reduces risk of injury during getting in/out of
the nursing bed.
If there is not enough space for the standard mobile hoist, use overhead
lifts.
Make sure when adjusting the bed that no patient, operator or any other
people, especially children can be jammed or injured.
The nursing bed must be cleaned and washed down with disinfectant
in case of a patient change or in other situation required it.
There must be a minimum height of 22 cm without compression
measured from the top of the mattress to the top edge of the top side
rail. This is illustrated on the picture on the next page.