- 9 -
STEP 2
For the MSI MPG X570S Carbon EK X series water block to operate
properly the G1/4 port nearest to the right edge of the water block
MUST BE USED AS THE INLET PORT
.
EK recommends the use of EK-Fittings. When using fittings other than
EK series please use hose clamps or appropriate substitute to secure
the tubing to the barb. The use of biocide containing and corrosion
inhibiting coolant is always recommended for any liquid cooling
system.
STEP 2
IMPORTANT:
USE THIS OPENING
AS AN INLET PORT!
ATTACHING BLOCK ON THE MOTHERBOARD
STEP 1
Prior to fastening the screws please make sure the mounting holes
on the motherboard’s circuit board are aligned with the water block.
Mosfet part:
Use four (4) M2.5 x 5 AX1 Screws with PVC washers.
Tighten the screws evenly. Do not use excessive force when
tightening the screws.
CPU part:
Use four (4) M3 x 10 DIN 7984 with screws. Tighten the
screws using enclosed 2mm Allen Key.
Do not forget install the Backplate Insulator and AM4
Backplate (as shown on the photo).
STEP 1
PVC WASHER
M3x10 DIN7984
M2.5x5 AX1 SCREW
BACKPLATE
INSULATOR
AM4 BACKPLATE