Revision 1.0. Released on 1
st
of June, 2012.
Installation and mounting manual for EK-XTOP Revo D5 PWM
(incl. pump)
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
1.
Please carefully read the manual before through before beginning with the installation process!
2.
The EK High Flow and EK-PSC type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.
3.
The use of corrosion inhibiting coolants is always recommended for any liquid cooling system.
STEP 1: PREPARING THE PUMP
(already done by EK)
STEP 2: PREPARING MOUNTING HOLES
Unscrew the ribbed threaded ring that attaches the Laing pump’s
original factory top and the main pump core housing with motor.
Store the original top, the original o-ring gasket and the attaching
ring in a safe place.
First you have to prepare place where the pump will be installed.
Take enclosed sticker which has 4 designated holes.
Stick it to the PC case where you want to place the pump. Be careful of correct pump position. (Step 4)
Take a drill (5mm) and drill 4 holes on designated points.
STEP 3: INSTALLING THE XTOP AND HOLDER
(already done by EK)
XTOP comes in two (2) port version. Pump Top has central inlet port and side OUTLET port (see right picture below).
1. Take the sealing gasket [2] and place it on the pump [3].
2. When the sealing gasket is in place take the pump and place it into the XTOP [1]. You can rotate XTOP to alternate the position of the OUTLET PORT to meet your
requirements.
3. Fix the pump [3] on the XTOP [1] using nut [4].
4. Take the rubber dumper [5] and place it into the Holder [6] as shown on the picture below.
5. When the Dumper [5] is installed in to the Holder [6] push the assembled part onto the Pump [3]. You can rotate the pump to alternate position of the outlet port to meet
your requirements.
6. Take the Screws M3x12 [8] and secure the pump onto to the holder. You should use Allen Key 2mm. Plate [7] with two M3 thread holes is preinstalled by EK.
7. Now you successfully assembled the pump. Position the bottom Holder [6] holes on to the previously drilled holes and secure the assembled pump with FOUR enclosed screws
M4x10 and PVC washers [9].
Factory original
pump top
D5 pump body with
motor
Twist LEFT to unscrew!
Mounting holes
1
2
3
4
5
6
7
8
9
Inlet port
Outlet port
EK Badge
