2nd revision, Dec 15th 2016
EK-RES X4
USER GUIDE
GENERAL INFORMATIONS
/ 1 /
CONTENT:
- EK-RES X4 series reservoir
- Reservoir holders (universal and bottom)
- LED light strip
- Pair of pre-cut solid Acrylic tubes
- Mounting mechanism
/ 2 /
INSTALLING THE RESERVOIR HOLDERS
EK-RES X4 series reservoirs comes with two special holders. These hold-
ers are meant to be installed directly on the computer chassis or alterna-
tively fan holes. User may need to drill up to 4 (four) Ø5mm holes through
chassis metal using electric power drill if there are no appropriate mounting
holes available.
TOP
OR 4x2
71x2,5 gasket
Glass tube (200mm)
Anticyclon
Rod
M3x8 INOX screw
71x2,5 gasket
Bottom
Screw
The RES X4 UNI holder is intended to be
mounted anywhere in the chassis and in
any possible direction. The gap between the
mounting holes is 105mm, therefore it can
also be mounted on 120mm fan holes. Se-
cure the holder using the 2 (two) M4x10 DIN
7984 screws, PVC washers and M4 nuts.
The RES X4 120mm fan holder is intended to be mounted on the bottom
of the chassis . The gap between the mounting holes is 105mm, therefore
it can also be mounted on 120mm fan holes. If you want to mount the
holder on the fan, you should use 4 (four) self-tapping screw, otherwise
you must use the enclosed 4 (four) M4x10 DIN 7984 screws, secured
with nuts and washers.
ATTACHING THE RESERVOIR ON THE HOLDERS
/ 3 /
In order to mount the RES X4 onto the RES X4 UNI holder you should
follow the steps below:
STEP 1:
Take the RES X4 reser-
voir and guide the RES X4 Bot-
tom into the bottom circular jaws
of the holder.
STEP 2:
Gently push the reser-
voir into the bottom jaws so that
they bend a little. When pushing
down guide the upper jaws of
the holder into the TOP groove.
STEP 3:
Push the upper part of
the reservoir into the upper jaws.
It should slide in smoothly.
The RES X4 120mm fan hold-
er should be mounted before
this step. Take the reservoir and
guide the bottom part through
the circular part of the holder. The
holder has a seat on the bottom
manifold of the RES X4. Make
sure that holder grabs the whole
circumference of the reservoir
bottom firmly.
UNIVERSAL HOLDER
BOTTOM HOLDER
