- 10 -
M2.5 Nut
1 pcs
For this Step, you will need:
M 2.5 PVC Washer
(19 pcs)
Phillips Head
Screwdriver
M2.5 x 4 AX1
(19 pcs)
4 mm
STEP 2
M2.5 x 4 AX1 SCREW
M2.5 PVC WASHER
M2.5 NUT
STEP 2
ATTACHING THE BLOCK TO THE GRAPHICS CARD
Use nineteen (19) M2.5 X 4 AX1 screws and M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver. EK
recommends you start tightening the screws around the GPU core
first and then continuing outward to prevent damage to the GPU.
Always use a plastic washer under each screw! For one (1) M2.5
screw marked with red triangle you will also need one (1) M2.5 Nut to
succesfully attach bracket to pcb.
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
This procedure is the same for all full-cover water blocks.
Carefully position the water block with preinstalled standoffs on
the graphics card. During this process, make sure you have aligned
mounting holes of the PCB with holes of the water block (the same
applies to other tops).
Pay attention not to use too much force when pressing the
block down to the PCB since chip dies are prone to cracking.
STEP 1