All disclosures, notices and warranty conditions are being written on EKWB web page. Please check terms of use.
Revision 2.0. Published on November 23
rd
2016
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no
liability whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
1.
Please carefully read the manual before through before beginning with the installation process!
2.
Please remove your motherboard from the computer to assure safest mounting process in order to prevent any possible damages to your CPU and/or motherboard’s circuit board (PCB).
3.
The EK-HFB and EK-ACF type fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber o-ring gaskets.
4.
The use of quality, market proved corrosion inhibiting coolants is always strongly recommended for any liquid cooling system.
STEP 1: GENERAL INFORMATION Sample photo of MSI Z170A XPower Gaming Titanium Edition motherboard
STEP 1: PREPARING YOUR MOTHERBOARD
REMOVING STOCK COOLER.
Remove all encircled screws. There are 4 screws on the back of the motherboard that needs to be removed in order to remove the factory
installed SB/MOSFET heat pipe cooling solution.
STEP 2: PREPARING YOUR MOTHERBOARD
1. APPLYING THERMAL COMPOUND
. Apply thermal compound on
CPU heat spreader
(IHS) - see sample photo on right
with enclosed EK-TIM Ectotherm thermal grease.
The quantity of about two rice grains is just about right. There is no need to cover the whole
IHS. Applying too much thermal grease will have negative impact on the cooling performance!
2. CUTTING THERMAL PADS.
Your block comes with thermal pads which needs to be trimmed in order to fit the voltage regulation area (MOSFET) on the motherboard’s
circuit board. WARNING: DIMENSIONS ON PICTURES BELOW ARE SCALED.
Replacement thermal pads @ EKWB web shop:
Thermal PAD G 1mm - (120x24mm) [EAN: 3830046996770]
Do not remove
the Z170 PCH
(SB) Cooler!
Installation manual for EK-FB MSI Z170A XPower Te Monoblock water block
Z170 PCH
(SB)
CPU socket
Mosfets
Thermal pad G – 1.0mm
(for mosfets):
