- 11 -
ATTACHING THE WATER BLOCK
STEP 1
Carefully place the water block onto the motherboard and align four
(4) mounting screws with four (4) holes on the motherboard. Hold
the water block and the motherboard and turn them upside down.
Before placing the Water Block on the motherboard, make
sure all the Thermal Pads are placed correctly! (Chapter:
Cutting and placing thermal pads).
STEP 1
M2.5 x 4 SCREW
+ WASHER
STEP 2
Align the Backplate with the water block mounting screws. Turn the
backplate mounting nuts in the clockwise direction according to the
numerical order shown in the image.
After securing the backplate, screw in four (4) M2.5 x 4 Screws and
Washers (from the mounting bag) as shown in the picture.
Do not use excessive force!
STEP 2
For this step you will need:
Phillips Head Screwdriver
TURN
CLOCKWISE TO
SCREW
1
2
3
4
VELOCITY
2
BACKPLATE
MAX TORQUE:
0.6 Nm