EKOM invent DK50 DI, Руководство пользователя

Страница: 18 / 148

OPERATION
18 NP-DK50 DI-15_08-2020
First operation

Make sure that the pump inside of device was unsecured.

Check that the connection to the compressed air supply is correct.

Check for proper connection to the main power supply. Before the
equipment is plugged in, make sure that the voltage and frequency shown
on the equipment are the same as provided by the power connection.

Switch on the pressure switch to position “I”.
OPERATION
The equipment may only be operated by the trained staff!
In case of emergency, switch the equipment off at the switch and pull
out the main power plug.
Switching the compressor on
The compressor is switched on at the main power switch by putting it in
position "I". The compressor operates in one of the following modes
depending on the pressure in the central distribution line and on the
consumption of compressed air:
STANDBY / indicator flashing - when pressure in the central compressed air
line is sufficient and the power switch is on, the compressor is in standby
mode. The equipment functions as a backup compressed air source,
monitoring the pressure in the central compressed air line, with the
compressor coming online if the pressure drops to a pre-set level.
RUN / indicator permanently displayed - the compressor operates at low
pressure in the central compressed air line or if the equipment is not
connected to a central compressed air line.
Running the compressor
The display shows the value of outlet pressure in BAR or PSI units. Change
of units is available, contact your service representative.
Total operating hours indicator displaying total operating hours. For
preventive maintenance hours see chapter Maintenance.
Alarm system
All alarm states of the equipment are states of the middle priority technical
alarm according to EN 60601-1-8. Each alarm state is indicated by the
corresponding visual and auditory signal (see Chapter 2 - Display Unit and
Chapter 3 - Technical Data).