EKOM DK50 4x4VRT/M, Руководство пользователя

Страница: 28 / 74

INSTALLATION
NP-DK50-Nx4VRTM-AD-A-EN-4_03-2021 28 03/2021
Fig. 14: Air outlet from the air tank
Potential for damage to pneumatic components.
Ensure the air hoses are not kinked.
12. ELECTRICAL CONNECTION
Unauthorised interference hazard
Only a qualified electrician may install electrical components!
Risk of damage to the device.
The operator is obliged to provide circuit protection devices for the equipment
per the specifications in valid technical standards.
The product is delivered without a power cord.

Connect the compressor module to the dryer module using cable W22 (Fig. 15).

Connect the compressor module to pressure sensor B1 located on the air tank using cable
W23, which is terminated with a valve connector. (Fig. 17)
The manufacturer recommends protecting cabling loose on the floor (W22 and W23) with a
cable bridge.

Connect the individual power cord conductors to the power terminals L1, L2, L3, N(BU),
PE(GNYE). (Fig. 19)

Recommended configuration of phase conductors: L1-BN, L2-BK, L3-GY.

Cord type (minimum requirements) H05 VV-F_ 5G6
Route the power cord out of the enclosure as illustrated. (Fig. 18)