EKOM DK50 2x4VR/110/M, Руководство пользователя

Страница: 27 / 168

INSTALLATION
09/2020 27 NP-DK50 2x4VR 110-AD-A-1_09-2020
Fig. 16: Connecting the control harness and power cord
Risk of fire and electric shock.
Electrical cable must not be in contact with hot compressor components.

Connect the pin for equipotential bonding 6

mm
(1) to the electrical circuit using the defined
method under valid electrical engineering
regulations

The socket for equipotential bonding (2) is an
accessory and is not provided in the basic
package
Fig. 17 :Equipotential bonding

Mount the connector of the grounding conductor on the door and screw on the cabinet.
12.1. Connecting a compressor not installed in a cabinet

Insert the mains plug into a rated mains socket.

The compressor is ready for operation.
12.2. Connecting a compressor installed in a cabinet

Route the mains plug through the opening in the rear wall of the cabinet for cabinet-mounted
compressors.

Connect the cabinet electrically to the compressor by inserting the provided power cord with
connector into an outlet. (Fig. 18)

Disconnect the cabinet electrically from the compressor by pulling the connector from the outlet
while the latch is released.