EKOM DK50-10 Series, Руководство пользователя

Страница: 33 / 120

PRODUCT MAINTENANCE
10/2019 33 NP-DK50-10-A-4_10-2019-MD
17.5. Condensate drain
Compressors
Open the drain valve carefully and slowly. If the drain valve is opened too much,
it is accompanied by high noise level and uncontrolled jet of the accumulated
condensate
Risk of slipping on a wet floor in case of the collecting vessel overflow.
During regular operation, it is recommended to drain
condensate from the pressure tank.

Switch off the compressor from the mains and
decrease air pressure in the device to max. 1 bar,
e.g. by releasing air through the connected device.

Install the hose with condensate drain valve into
the prepared bottle and drain condensate from the
tank by opening the drain valve (1).
Fig. 10: Condensate drain from the pressure tank
Compressors without a dryer may be equipped with the Automatic Condensate Drain to allow the
condensate to drain without operator intervention (see Chapter 7 - Accessories).
Compressors with air dryer
Condensate from compressors with air dryers is
automatically drained into the condensate collection
vessel

Monitor the level in the vessel using the 1 l or 2 l
markings (depending on the volume of the vessel),
and empty at least once a day.
Fig. 11: Check of condensate collection vessel
Before the following checks it is required:

Compressors in cabinet - DK50-10 S, DK50-10 S/M
– remove the cabinet / lift the cabinet up.

Compressors in cabinet DK50-10 S/M 10bar - dismantle the cabinet cover, disconnect cabinet
connector and remove the cabinet / lift the cabinet up.