EKKO EP30A, Руководство пользователя

Страница: 16 / 32

11
8.
Operating Instruction
Before operation, please familiarize yourself with the functions of the switches and buttons
on the dashboard.
8.1
Start, run and parking:
1).Insert the key into the key switch, turn to the right, pull the emergency stop switch up,
open the control circuit.
2).Forks rise above ground about 4 inch
3).Slowly rotate the accelerator to start the truck, till the requested speed
4).Any fault of the truck happening during operation, need to cut off the power immediately,
and press the red emergency stop switch down.
5).When the truck is turning, the speed should be reduced. If possible, try not to make a
sharp turn.
6).The full load gradient of the truck is 5%, Using truck Full load climbing a slope, need to
know the condition of the slope, and press the Accelerator switch as much as possible to get
a maximum grade ability.
7).When stop driving, put the fork in the bottom, press the emergency stop switch down,
and pull out the key.
8.2
The usage of emergency stop switch
If the truck is out of control during driving, or if it is smoked or burnt during use, please
press the emergency stop switch on the instrument panel of the truck and the main power
will be cut off. Find out the cause and clear the fault and then you can open it . Method to
open it: gently pull the red button up.
Emergency stop switch is made of plastic , too much pressure may damage it.