TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 8 _________________________________________________________________________________________
8. Routine cleaning and maintenance
(WARNING: Cut power to the appliance before every operation)
General cleaning - Clean the appliance when it is cool To clean the steel parts, do not use
products containing chlorine (sodium hypochlorite, hydrochloric acid, etc) even if diluted. Use
specific off-the-shelf products or a little hot vinegar. Rinse thoroughly with water and dry with
a soft cloth. Clean the glass door with hot water only, and do not use rough cloths. Do not
wash the appliance with direct jets of water, because if water enters, this could limit the
appliance's safety. Do not use corrosive substances (e.g. hydrochloric acid) to clean the floor
near to where the appliance could be located: the vapours released by this acid could corrode
and damage the appliance's outer housing in steel.
9. Technical assistance
Before leaving the factory, the appliance was completely regulated and tested by expert
specialised personnel to guarantee the best operating results.
All repairs and settings must be performed with utmost care and attention, respecting national
safety regulations in force. Always contact your retailer or our nearest Service Centre, giving
details of the problem, the appliance model and the serial number (on the rating plate on the
rear panel).
For any maintenance the user can contact Tecnoeka by calling the telephone numbers on the
cover or going to
10. Information to users
Pursuant to Directive 2012/19/UE the crossed out bin symbol on the appliance
indicates that at the end of its life the product must be collected separately
from other waste.
The user must, therefore, deliver the appliance at the end of its service life to
the appropriate centres for separate collection of electrical and electronic
waste.
The separate waste collection and subsequent treatment, recovery and disposal,
are conducive to the production of equipment with recycled materials and
reduce the negative effects on the environment and health possibly caused by
improper waste handling.
