Eizo Raptor SQ2801, Руководство пользователя

Страница: 23 / 59

2.3.1 Analog RGB – Interface
The analog RGB input may be used for Sony DDM compatible configurations. However, the Raptor
SQ2801 panel can also handle all common VESA timings. When using this interface, specific
adjustments for phase and frequency may be necessary. These adjustments are explained in detail in
section 3.3 on page 41.
For connection with the analog video source, a high quality coaxial cable must be used. The three
video signals (red, green and blue) require 50 ohm impedance on the coaxial cable while the
synchronization signals (hsync and vsync) must have 75 ohms impedance. Signal cables of poor
quality may cause distortions and shadowing in the displayed picture.
Technical data pertaining to the analog RGB interface is discussed in section 5.6 on page 55.
Fig. 13: Connector type: 5 x BNC socket
V-Sync H-Sync Blue Green Red
2 General Installation
23