Eizo RadiForce GX240-CL, Инструкция по эксплуатации

Страница: 13 / 55

13
Chapter2AdjustingScreens
●
To set the mode in the base display area
The mode suitable for the base display area can be set.
Setting Range
Base-L, Base-H
Procedure
1. Choose “Mode” from the Adjustment menu, and press .
2. Choose “Base Area” from “Mode”, and press .
3. Select “Base-L” or “Base-H” with or .
Mode Purpose
Base-L Specifiesthetargetbrightnessat100cd/m
2
.
Base-H Specifiesthetargetbrightnessto170cd/m
2
.
4. Press to exit.
Attention
• After the configuration in the display area, you cannot select any mode for which Mode Preset is “Off” (see “3-2.
Enabling/Disabling Mode Selection” (page 14) ).
Note
• If the brightness value in the base display area is higher than the target brightness, the target brightness is applied for
Base-L and Base-H.
●
To set the detection type in the image display area
You can set the detection type in the display area.
Procedure
1. Choose “Mode” from the Adjustment menu, and press .
2. Choose “Hybrid Assignment” from “Mode”, and press .
3. Select “Full Scan”, “Partial Scan”, or “Custom” with or .
Detection
Type
Purpose
FullScan Identifiesthedisplayareaautomatically.
PartialScan Identifiestheselectionareausingsoftware(HybridGammaManager)automatically.
Custom Allowsyoutosetthedisplayareamanuallyusingsoftware(HybridGammaManager).
4. Press to exit.
Note
• For Hybrid Gamma Manager, contact your local dealer.
●
To set the highlight area in the image display area
You can set On/Off for the highlight area in the image display area.
Procedure
1. Choose “Mode” from the Adjustment menu, and press .
2. Choose “Highlight Area” from “Mode”, and press .
3. Select “On” or “Off” with or .
4. Press
to exit.
Note
• You can set On/Off for the highlight area with .