28
Chapter 6 Reference
Chapter 6 Reference
6-1. Attaching the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our
web site for the supported optional arm (or optional stand).
Attention
•
When attaching an arm or stand, follow the instructions of the respective User’s Manual.
•
When using another manufacturer’s arm or stand, confirm the following in advance and select one conforming to
the VESA standard. Use the screws securing the unit and the stand.
- Clearance between screw holes: 100 mm × 100 mm
- Plate thickness: 2.6 mm
- Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables.
•
When attaching an arm or stand, the installable orientations and movement range (tilt angle) are as follows:
Orientation
Movement
range
(tilt angle)
Up: 45˚
Down: 45˚
Up: 45˚
Down: 45˚
•
Connect the cables after attaching an arm or stand.
•
Do not move the removed stand up and down. Doing so may result in injury or device damage.
•
The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
