24
Chapter 3 Advanced Adjustment/Setting
Function
Setting Range
Description
Power Save
On
Off
The monitor can be set to enter power saving mode according to the
state of the PC.
The monitor changes to power saving mode about 15 seconds after
signal input ceases to be detected.
When the monitor has shifted to power saving mode, images are not
displayed on the screen.
•
Exiting power saving mode
- If the monitor receives input, it automatically exits power saving
mode and returns to the normal display mode.
Note
•
At the time of shifting to power saving mode, a message that
indicates the transition is displayed 5 seconds in advance.
•
During PbyP display, the monitor only enters power saving mode
after both PCs have entered power saving mode or have been
switched off.
•
When not using the monitor, you can turn off the main power supply
or disconnect the power plug so that the power is cut completely.
•
When the monitor is in power saving mode, devices connected to the
USB downstream port will still work. Therefore, power consumption
of the monitor varies with connected devices even in power saving
mode.
Power Indicator On
Off
The power indicator (white) can be turned off during screen display.
Sound Selection
(PbyP)
Left
Right
Select the source of audio to output from the monitor during PbyP
display.
•
“Left”
Outputs the audio source from the left screen.
•
“Right”
Outputs the audio source from the right screen.
USB Power
Delivery
15W
30W
The supply wattage setting can be changed.
•
“15W”
Prioritizes the screen brightness. The power supplied by USB Power
Delivery is restricted to 15 W.
•
“30W”
Prioritizes the power supplied by USB Power Delivery. The screen
brightness is restricted.
Note
•
The device may not be supplied with power or charged depending on
the profile (voltage or current) supported by the connected device.
- This monitor supports the following profiles:
“15W” : 5 V / 3 A
“30W” : 5 V / 3A, 9 V / 3 A, 12 V / 2.5 A, 15 V / 2 A, 20 V / 1.5 A
•
The screen disappears temporarily when you have changed the
setting, but it returns to normal after a few seconds.
•
When you change the setting, remove any peripherals such as
a USB memory device connected to the downstream port of the
monitor.
Monitor Reset
-
Restore all settings to their default values except for the following
settings.
•
PbyP Picture Setup
•
“USB Power Delivery” setup
•
Settings on the “Administrator Settings” menu
Note
•
For details on default settings, see