Chapter 7 Reference
7-1. Attaching the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our
web site for the supported optional arm (or optional stand).
Attention
•
When attaching an arm or stand, follow the instructions of the respective User’s Manual.
•
When using another manufacturer’s arm or stand, confirm the following in advance and select one conforming to
the VESA standard.
- Clearance between screw holes: 100 mm × 100 mm
- Plate thickness: 2.6 mm
- Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables.
•
When using another manufacturer’s arm or stand, use the screws as described below.
- Screws fixing the stand to the monitor
•
When attaching an arm or stand, the installable orientations and movement range (tilt angle) are as follows:
Orientation
Movement range
(tilt angle)
0˚
Up: 90˚
•
Connect the cables after attaching an arm or stand.
•
The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
•
Check periodically that the screws are tight enough. If the screws are not tight enough, the monitor may come
unattached. This may be the cause of injury or damage.
1.
Lay the LCD monitor on a soft cloth spread over a stable surface with the
panel surface facing down.
2.
Remove the stand.
Using a screwdriver, loosen the screws securing the unit and the stand.
32
Chapter 7 Reference
