39
Chapter 6
Reference
6-7. Specifications
LCD Panel
Type
IPS (Anti-Glare)
Backlight
Wide color gamut LED
Size
61.1 cm (24.1 inch)
Resolution
1920 dots x 1200 lines
Display Size (H x V)
518.4 mm x 324.0 mm
Pixel Pitch
0.270 mm x 0.270 mm
Pixel Density
94 ppi
Display Colors
Approx. 16.77 million colors (8 bit colors)
Viewing Angle (H x V, typical) 178˚ / 178˚
Contrast Ratio (typical)
1000 : 1 (When "DUE Priority" setting is "Brightness")
Response Time (typical)
Gray-to-gray: 14 ms
Color Gamut Display (typical) sRGB coverage 100%, NTSC ratio 79%
Video Signals
Input Terminals
DisplayPort 1.1a (HDCP 1.3 compatible) x 1,
HDMI (HDCP 1.4, Deep Color compatible)
*1
x 1,
DVI (Single Link, HDCP 1.4 compatible) x 1
*1 Not compatible with HDMI CEC function (mutual control
function).
Horizontal scan frequency
DisplayPort: 26 kHz to 78 kHz
HDMI (Video mode): 15 kHz to 68 kHz
HDMI (PC mode): 26 kHz to 78 kHz
DVI: 26 kHz to 78 kHz
Vertical scan frequency
DisplayPort: 23 Hz to 63 Hz (For 720 x 400: 69 Hz to 71 Hz)
HDMI (Video mode): 23 Hz to 61 Hz
HDMI (PC mode): 23 Hz to 63 Hz
HDMI (for 720 x 400): 69 Hz to 71 Hz
DVI: 23 Hz to 63 Hz (For 720 x 400: 69 Hz to 71 Hz)
Frame Synchronization mode 23.75 Hz to 30.5 Hz, 47.5 Hz to 61.0 Hz
Dot clock (Max.)
164 MHz
USB
Port
Upstream
USB Type-B (USB3.1 Gen1) x 1
Downstream
USB Type-A (USB3.1 Gen1) x 3
(The "CHARGE" port supports quick recharging)
Standard
USB Specification Revision 3.1 Gen 1
Communication Speed
5 Gbps (super), 480 Mbps (high), 12 Mbps (full), 1.5 Mbps (low)
Supply Current Downstream
USB Type-A (USB3.1 Gen1): Maximum 900 mA per port
USB Type-A ("CHARGE" Port): Normal: Maximum 1500 mA
per port, Charging Only: Maximum 2100 mA per port
Power
Input
100-240 VAC ±10 %, 50/60 Hz 0.60 A to 0.30 A
Maximum Power Consumption 57 W or less
Power Save Mode
0.7 W or less (this applies when the OS turns to sleep mode or
when the monitor's power off setting is activated, if the monitor
has DisplayPort input signal only, "Auto Input Detection" is set
to "Off", no USB device is connected, and "USB CHARGE
Port" is set to "Normal")
Standby Mode
0.6 W or less (when "Auto Input Detection" is set to "Off",
no USB device is connected, "USB CHARGE Port" is set to
"Normal", and "DP Power Save" is set to "On")
